Coleman 5036 Spécifications télécharger pdf (Page 5)

Electronic Ignition

■ Turn valve to HI

position and push the red

IGNITOR BUTTON until

heater ignites (10-12

seconds).

■ Heater will ignite with a

brief visible flame.

■ Heater is adjustable to “HI” and “LOW”.

■ NOTE: Heater is

designed to be lit with

the valve fully open until

it reaches full output.

Observe heat build up

for a few minutes to

ensure heater is lit. If

heater fails to develop

substantial heat, turn

heater “OFF” and repeat

lighting procedure.

To Light cont

To Turn Off

■ Turn FUEL VALVE to

OFF.

■ Allow HEATER to

cool for 10-15 minutes.

DANGER

• EXPLOSION - FIRE HAZARD

• Never store propane near high heat, open flames,

pilot lights, direct sunlight, other ignition sources or

where temperatures exceed 120 degrees F (49°C).

To Store

Support Leg Assembly

Support Leg

Match Light

■ Hold match as shown.

■ Turn valve to HI

position.

■ Heater will ignite with a

brief visible flame after

10-12 seconds.

■ Heater is adjustable to

“HI” and “LOW”.

Note: If unit fails to light, check that you have

a fresh battery. You may also use the match

light procedure below:

■ A wire Support Leg is supplied with your unit as

an alternate means to support your heater.

■ Insert the wire Support Leg into the receiver holes

provided on each side of the heater head. Make sure

the support is fully inserted. The short wire studs

should rest against the metal heater head.

■ Before lighting, place the heater with Support Leg

on a flat and stable surface.

CAUTION

• When using the

Support Leg Assembly,

DO NOT leave the Cup

Holder Adapter on the

heater.

Cup Holder Adapter

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Coleman 5036 Spécifications Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Chauffages d'appoint Coleman 5036