Coleman RANGEVIEW 5 9230-110 Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
The Coleman Company, Inc. • 3600 N. Hydraulic • Wichita, Kansas 67219
1-800-835-3278 • www.coleman.com
MADE IN CHINA • PRINTED IN CHINA
© 2006 The Coleman Company, Inc.
Coleman
®
and are registered trademarks of The Coleman Company, Inc.
STITCH LINE
7. Tie guylines onto web
straps located at front
and back of rainfly,
stretch until taut, and
secure with stakes.
(Fig. 11,12 & 13)
Fig. 13
Guylines
Door and Window Vents
1. To use the door vent, undo
zipper from inside of tent,
then roll down flap and fasten
with toggle and fabric loop.
(Fig. 14 & 15)
2. To open rear window vent for
more ventilation, unzip, then
roll down and insert toggles
through fabric loops. (Fig. 16)
3. Door flap can be rolled back
and secured with toggle and
fabric loops. (Fig. 14 & 15)
To Attach Rainfly continued
Fig. 14
Cooler Access
The smaller zippered opening at the
side of the tent is designed for added
ventilation and easy access to your
beverage cooler.
1. To use as a vent, unzip flap to
expose screen. (Fig.17)
2. To use as a cooler access, unzip
other flap to make an avenue to
bring beverages into the tent.
(Fig.18)
Fig. 17
Fig. 18
Electrical Cord Access
1. Unzip access panel in
the lower right corner
of tent and bring in
electrical cord.
Use only UL approved
cords that are rated
for outdoor usage.
(Fig. 19)
Fig. 19
Things You Should Know:
Under certain conditions (cold weather, high humidity, etc.) condensa-
tion will form on the inside of your tent. Condensation is caused by
water vapor from your breath, perspiration, or any wet clothing inside
the tent. It is NOT LEAKAGE through the tent fabric. It can be minimized
by removing wet clothing from your tent and by providing good ventila-
tion through the tent.
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles
inside your tent. Use a separate storage bag.
Stakes should be removed by pulling on the stake itself. Never pull on
the tent to remove stake.
TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER
DURING STORAGE.
Do not leave your tent set-up for weeks at a time. Be aware that exposure
to ultraviolet rays from the sun can seriously damage material and/or
cause it to become discolored.
WARNING: Keep all flame and heat sources away
from this tent fabric.
This tent meets the flammability requirements of CPAI-84. The
fabric may burn if left in continuous contact with any flame source.
The application of any foreign substance to the tent fabric may
render the flame-resistant properties ineffective.
To Store
1. All metal poles and stakes must to be placed in the storage
bag to prevent damage to the fabric items placed in the
carry case.
2. Make sure tent is clean and dry before placing in carry case.
3. Remove rainfly, spread out on floor of tent, then unzip
door & vents before taking tent down for storage.
4. Neatly fold tent to width of pole storage bag, place on tent,
roll tightly, and place in carry case.
5. Store in a clean, dry area.
12/06
Fig. 12
Fig. 11
Fig. 15
Fig. 16
Door Vent
Door Flap
Window
Flap
Storage
Pocket
Door Mat
1. Unfold door mat and
secure with stakes.
(Fig. 20)
Fig. 20
Vue de la page 1
1 2

Commentaires sur ces manuels

Pas de commentaire